Current “State of the Fiddles” report.

Please share with your friends!

Slow Progress, But Moving Along!

Scroll-carving

I spent most of Saturday working on carving the viola scroll. I am not as fast as a lot of luthiers seem to be. It takes me more than eight hours to carve a scroll, and I can’t go at it for eight hours straight, anymore, anyway. So, between the heat and my other responsibilities, this is pretty much all I got done. It is still not complete, of course, but it is looking closer to complete, and it feels encouraging, to look at it.

This is a Big Leaf Maple scroll and back, on top of a Sitka Spruce top plate. It is interesting to carve domestic maple in close proximity to European maple. They are not the same at all. The big leaf maple is much softer, and feels almost fuzzy, under the scraper. Much lighter-weight, too, and has a different ring, when I tap it. European seemsto be  superior for violins, though domestic maples seem to work fime for larger instruments (or possibly it is the lower tones involved.) This instrument will be a good “experiment” in that regard. If  this instrument is very good, then the lower tone is the issue– if it is questionable, I may repeat the experiment immediately with European Maple and see if that corrects it. If it does, then the size of the instrument may be what is the problem.

But I suspect it will be a very good viola. I have made other very small (14-7/8″ on the body) violas using the same woods, before, and they were very good. This will be the smallest I have made, using domestic woods.

Partially completed scroll for the 14
Partially completed scroll for the 14″ viola

 

Planing and flattening the plates

Actually, come to think of it, I did do a little more– I went and used my son’s tools and planed the two violin plates to appropriate thicknesses to start working them.  I was shooting for about 17mm thick, to begin with, so that my finished arching will be close to that thickness, after everything else has been carved away. Then I laid-out the shapes of the plates by tracing them from the completed garland, and cut them out at home. So, here is what the whole pile looks like today. Last week, some of the plates were still square and flat, and very thick…this week they are all the correct thicknesses, and one scroll is nearing completion.

The lines on the right-hand maple plate (the viola back) are sketching in where the carving will happen on the inside of the plate: I will carve the outside first, to get the exact arching I have planned, then carve the inside to a similar shape, to get the exact thisknesses I hope to achieve (called “graduations” because the thickness is different in different areas, and changes gradually from area to area.) Both the arching and the graduations are critical to the final resulting sound. In my opinion,  the arching is probably more important, but I can’t prove it.

do know that when I accidentally arched some of my early violins the way (I later was taught) a viola is supposed to be arched, those violins sounded like violas, in spite of everything else about them being “violin.” It was very perplexing to me, at the time, as my ear was not well-enough trained to hear the difference, and all I knew is that it was a violin! And these crazy players kept telling me it sounded like a viola! They were right! The arching was the issue that decided the character of the sound. Good learning experience.

Current State of the Fiddles
Current State of the Fiddles

The wood on the left is European maple and spruce I bought from International Violin Co., in Baltimore, MD. I have used their wood before, and it has worked well. Both have linings and blocks made of weeping willow.

As you can see, both instruments have one-piece backs, and two-piece, book-matched fronts (sometimes referred to as tops, or bellies). In both cases the ribs and necks/scrolls are of  wood matching the back plate.

I will keep you all posted.

Thanks for looking.

If you found this post helpful, please share with your friends!