Button and Back Purfling

Please share with your friends!

Button and Back Purfling

Trimming the Button and Heel

When I installed the back plate, the heel had been trimmed flush with the back of the garland, but the upper surface of the heel was still quite irregular, and the upper end of the button was ridiculously oversized. The excess wood made it easy for me to install a clamp, and get the back plate glued on securely. So…when I removed all the clamps, this is what it looked like:

Back plate installed; button and heel not yet trimmed.

Back plate installed; button and heel not yet trimmed.

 

Tools for completion.

Next, I will trim the button and heel, then add purfling, then scrape. These are the tools I will use.

 

Button shape.

This is roughly the shape the button will be, but a little more refined, I hope.

 

Side view of heel and butto

Side view of the heel and the button. The closeness of the camera warps the picture a little.

 

Installing the Purfling

The next thing was to scribe in the purfling slot. I used the purfling marker to scribe the double line exactly 4mm from the outer perimeter of the plate, except the corners, where I used a sharp pencil to sketch the “bee-stings” in by hand. Then I incised the lines all the way around, just barely deepening the lines, so that they are more visible, and a little easier to follow with the blade of my small knife.

Purfling slot lines lightly incised.

Purfling slot lines lightly incised.

 

Then I slice in pass after pass, trying to get the lines deep enough for the purfling I will install. I usually find that, especially on the hard maple, I have to cut the slot in two layers: the first gets about half the depth I want, and the second finishes the slot. Here is the slot at half-depth:

Purfling slot, half-depth.

It looks good, but it is not deep enough.

 

Purfling slot ready for purfling.

Purfling slot ready for purfling.

 

Back purfling installed...glue still wet.

Back purfling installed…glue still wet. 🙂

 

Front view

And the Front!

 

Back to Work!

As most of you know, I had undergone hernia surgery, just after Christmas, and had a 6″ x 8″ polypropylene mesh patch installed in my abdomen. I have been convalescing, and just this week, have finally been feeling better. So…I just received word that I will return to my work at Gunderson, Inc., tomorrow at 6AM. I think I had better call it a day, and try to get some sleep. 3:30AM comes at the same time, every morning, whether I am ready or not. I will get home sometime after 4PM, I expect. Maybe I can jump back in where I left off. 🙂

Tomorrow evening, then, I hope to complete the purfling channel and the outer edgework of both the front and back plates, and begin the final scraping in preparation for varnishing. Any little glitch, regardless of how tiny, will be very visible under the varnish. So this part has to be done with great care.

 

Thanks for looking.

If you found this post helpful, please share with your friends!
4 Responses to “Button and Back Purfling”
  1. Maryanne G Jensen-Gowan
    02.15.2018

    The back looks like a piece of Renaissance silk!

  2. Chet Bishop
    02.15.2018

    Before my time… 🙂

  3. Rick Milliken
    02.16.2018

    Glad to hear the mending is working!

    That back really is very nice Chet. Really looking good.

    • 02.17.2018

      Thanks, my friend! Yep…getting well. Hoping to have the violin ready to begin the finishing sequence this weekend.


Leave a Reply